E5CC/E5EC-800

25

Operation

Setting Levels Diagram

This diagram shows all of the setting levels. To move to the advanced function setting level and calibration level, you must enter passwords. Some

parameters are not displayed depending on the protect level setting and the conditions of use.

Control stops when you move from the operation level to the initial setting level.

*1. To use a key procedure to move to Manual Control Level, set the Auto/Manual Select Addition parameter to ON and set the PF Setting parameter to a-m (Auto/

Manual).

*2. The No. 1 display will flash in the middle when the keys are pressed for 1 s or longer.

Press

(models with communications only).

Communications

Setting Level

Advanced Function

Setting Level

Power ON

Used to set application

functions.

Initial Setting Level

Operation Level

Used to set the input type

and other basic settings.

Used to set communications.

Used for SP, alarm values,

and other basic settings

and monitoring.

Used to change adjustment

parameters (PID constants,

adjustment sensitivity, etc.).

Used to set protection

for operations.

Press the

for at least 1 s.

Press the

Keys for at least 1 s.

Press the

for at least 3 s.*2

Press the

for at least 3 s.*2

Press the

Only when Manual Mode was

used just before power OFF

Level changes

automatically.

Protect Level

Manual Control

Level

Used to set the

MV manually.

Press the

Release protection and then

enter the password (−169)

for the

amoV (Move to Advanced

Setting Level) parameter.

or

while A-M is displayed

Adjustment Level