–

–

–

–

18

19

Development Kit Demonstration Software Example

This example shows how to configure two modules to work with each

other. The software defaults to the Advanced Configuration tab when

opened (Figure 21).

Install Carrier Boards onto the Programming Docks and plug a USB cable

between the Programming Docks and the PC. The software automatically

detects attached devices. The first module that is identified appears

under the Active label. This is the module that is actively controlled by

the software. Subsequent modules are listed under the Available label as

shown in Figure 22.

Once the modules are detected by the software, the appropriate options

are displayed on the Advanced Configurations tab and a Network tab

appears. The module’s documents appear under the Documentation link.

Figure 21: The Master Development System Software Advanced Configuration Tab at Start-up

Figure 22: The Master Development System Software Connected Modules

Any changes to the current configurations are shown in red. These

changes are not written to the module until the Submit button is clicked.

Changing the active module is accomplished by either clicking the play

symbol next to the desired module or dragging it from the Available list to

the Active spot. Changes can now be made to this module.

Figure 23: The Master Development System Software with Connected Modules

Figure 24: The Master Development System Software Advanced Configuration with Changes