–

–

–

–

26

27

This tab shows the advanced configurations enabled by the module’s

Command Data Interface. Any changes are highlighted in red. In the

example in Figure 28 the output mask has been changed to all inputs, S0 is

latched, the Paired module is given full permissions, the status line direction

is set by the mask and the outputs are latched by the Latch Mask. Clicking

the Set Module button sets the updated Permissions Mask. Clicking the

Submit button writes all of the changes to the module’s memory.

This configuration changes the module to have all outputs. This is shown

by clicking on the Demo & EZConfiguration tab Figure 29.

Figure 28: The Master Development System Software Advanced Configuration with Changes

The buttons have all changed to LEDs. The symbol next to each LED

indicates if it is latching or momentary (Figure 30). S0 is latching, the rest

are momentary.

Now that the modules are configured their use can be demonstrated.

Clicking a button on the transmitter module activates an LED on the

receiving module. Figure 31 shows the transmitter, Figure 32 shows the

receiver.

Figure 29: The Master Development System Software Demo and EZConfiguration Tab with Changes

Figure 30: The Master Development System Software Latching (1) and Momentary (2) Symbols

1

2