5.8kW Single-Phase Switched Automatic

Transfer Switch PDU, 2 208/240V L6-30P Cords,

16-C13 2-C19 & 1 L6-30R Outlet, 2U, TAA

MODEL NUMBER: PDUMH30HVATNET

Features

208/240V 30A Automatic Transfer Switch (ATS) / Switched PDU (Agency de-rated to 24A continuous)

q

ATS features provide redundant power for critical network equipment with a single input power cord

q

2 digit display reports output power consumption in amps

q

2U horizontal rackmount form factor; 12.5 in. / 31.8 cm depth

q

19 built-in switched outlets (16 C13, 2 C19 & 1 L6-30R)

q

Set of Plug-lock output power cable retention sleeves prevent accidental disconnection of connected

devices

q

Set of two 10-ft. / (3.05 m) NEMA L6-30P input cables support connection to separate PRIMARY and

SECONDARY inputs

q

ATS circuits normally maintain output sourced from the primary input cable; As primary input power fails

or becomes unstable, the ATS will switch to maintain output sourced from the secondary input cable

until power on the primary input is restored and stable

q

ATS configurations enable fault-tolerant, hot-swappable UPS protection when used with a single UPS

and fully redundant UPS protection when each cord is connected to a separate UPS system (in a two-

UPS environment, the primary input cable must be supported by an online UPS with zero transfer time

similar to Tripp Lite SmartOnline series)

q

Advanced ATS configurations utilizing separate mains circuits, backup generators and even separate

out of phase utility power grid feeds are fully supported

q

On-board ATS processor constantly evaluates power quality on both inputs to prevent transfer to the

secondary source when unavailable or of lower quality than the primary source

q

Super-fast switch-over between primary and secondary power sources occurs in 2-6 milliseconds

q

Highlights

Single phase 30A 208/240V

Auto Transfer Switch / ATS PDU

with Solid State Switching

q

Separate primary & secondary

inputs enable redundant-power

option for non-redundant

network devices

q

LX Platform Network Interface

q

2U rackmount, 2 L6-30P inputs,

19 switched outlets (16 C13, 2

C19, 1 L6-30R)

q

Individually switched outlets,

network interface and visual

current, voltage and

environmental monitoring

q

Compliant with the Federal

Trade Agreements Act (TAA) for

GSA Schedule purchases

q

To enable the Auto Probe

feature, this product requires LX

firmware update 15.5.2 or later

to be installed

q

Package Includes

2U PDUMH30HVATNET 30A

ATS SWITCHED PDU

q

2U rackmount installation

brackets

q

(16) IEC C13 plug retention

sleeves

q

(2) IEC C19 plug retention

sleeves

q

(1) Micro-USB-to-USB A

configuration cable (73-1689)

q

User manual

q

1 / 4