SR2 datasheet(3/22 Pages) STMICROELECTRONICS

3 / 22 page

DocID026047 Rev 2

3/22

SR2

Description

The Smart Reset™ devices provide a useful feature that ensures inadvertent short reset

push-button closures do not cause system resets. This is done by implementing extended

Smart Reset™ input delay time (tSRC) and combined push-button inputs, which together

ensures a safe reset and eliminates the need for a specific dedicated reset button.

This reset configuration provides versatility and allows the application to distinguish

between a software generated interrupt and a hard system reset. When the input push-

button are connected to microcontroller interrupt inputs, and are closed for a short time, the

processor can only be interrupted. If the system still does not respond properly, continuing

to keep the push-button closed for the extended setup time tSRC causes a hard reset of the

processor through the reset output.

The SR2 has two combined delayed Smart Reset™ inputs (SR0, SR1) with preset delayed

Smart Reset™ setup time (tSRC). The reset output is asserted after both of the Smart

Reset™ inputs were held active for the selected tSRC delay time. Depending on selected

option the RST output remains asserted either until at least one SR input goes to inactive

logic level (i.e. neither fixed nor minimum reset pulse width is set) or the output reset pulse

duration is fixed for tREC (i.e. factory-programmed). The reset output, RST, is active low or

active high, push-pull or open drain with optional pull-up resistor. The device fully operates

over a broad VCC range 1.65 V to 5.5 V. Below 1.575 V typ. the inputs are ignored and

outputs are deasserted; the deasserted reset output levels are then valid down to 1.0 V.

1.1

Test mode

After pull of SR0 up to VTEST or more (VCC + 1.4 V, max.) we start counting initial shorten

tSRC-INI (42 ms, typ.). After tSRC-INI expires, the RST output either goes down for tREC (if

tREC option is used) or stays low as long as overvoltage on SR0 in detected (if tREC option is

not used). This is a feedback and a user knows that the device is locked in the test mode.

Each time both SR inputs are connected to ground in test mode a shorten tSRC-SHORT (21

ms, typ.) is used instead of long tSRC (0.5 s -10 s). Return from to normal mode is possible

by a new startup of the device (i.e. VCC goes to 0 V and back to its original state). In this way

the device can be quickly tested without repeating test mode triggering. Advantage of this

solution is pretty high glitch immunity, feedback to user about entry to the test mode and

testability within full VCC range.

SR2 数据表(PDF) 3 Page - STMicroelectronics

SR2 数据表(HTML) 3 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22

数据表下载