PI3B3253 datasheet(2/7 Pages) DIODES

2 / 7 page

A product Line of

Diodes Incorporated

PI3B3253

www.diodes.com

September 2017

Diodes Incorporated

PI3B3253

Document Number DS40212 Rev 1-2

Capacitance (TA = 25°C, f = 1 MHz)

Parameters(1) Description

Test Conditions

Typ.

Units

CIN

Input Capacitance

VIN = 0V

3.0

COFF

IA/IB Capacitance, Switch Off

8.0

CON

IA/IB Capacitance, Switch On

36.0

DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC =3.3V ±10%)

Parameters

Description

Test Conditions(1)

Min.

Typ.(2)

Max.

Units

VIH

Input HIGH Voltage

Guaranteed Logic HIGH Level

2.0

VIL

Input LOW Voltage

Guaranteed Logic LOW Level

–0.5

0.8

IIH

Input HIGH Current

VCC = Max., VIN = VCC

±1

µA

IIL

Input LOW Current

VCC = Max., VIN = GND

±1

IOZH

High Impedance Output Current

0 ≤ IN, YN ≤ VCC

±1

VIK

Clamp Diode Voltage

VCC = Min., IIN = –18mA

–1.2

RON

Switch On-Resistance(3)

VCC = Min., VIN = 0.0V,

ION = 48mA or 64mA

Ω

VCC = Min., VIN = 2.4V, ION = 15mA

Notes:

This parameter is determined by device characterization but is not production tested.

Storage Temperature .....................................................................–65°C to +150°C

Ambient Temperature with Power Applied ....................................–40°C to +85°C

Supply Voltage to Ground Potential ................................................–0.5V to +4.6V

DC Input Voltage .............................................................................–0.5V to +4.6V

DC Output Current........................................................................................ 120mA

Power Dissipation ............................................................................................ 0.5W

Note:

Stresses greater than those listed under MAXIMUM

RATINGS may cause permanent damage to the

device. This is a stress rating only and functional

operation of the device at these or any other condi-

tions above those indicated in the operational sec-

tions of this specification is not implied. Exposure

to absolute maximum rating conditions for extended

periods may affect reliability.

Maximum Ratings

(Above which the useful life may be impaired. For user guidelines, not tested.)

Notes:

For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

Typical values are at VCC = 3.3V, TA = 25°C ambient and maximum loading.

Measured by the voltage drop between I and Y pin at indicated current through the switch. On-Resistance is determined by the lower of the voltages on the two

(I,Y) pins.

PI3B3253 数据表(PDF) 2 Page - Diodes Incorporated

PI3B3253 数据表(HTML) 2 Page - Diodes Incorporated

Html Pages

1 2 3 4 5 6 7

数据表下载