info@magigoo.com

www.magigoo.com

MAGIGOO

Thought3D Ltd, Unit2150, KBIC, Kordin Industrial Estate

Paola, PLA3000, Malta

Part should become easier to remove after sufficient cooling (maximum half

an hour after printing).

The best and most reliable performance is achieved when Magigoo

Polypropylene is applied as a thin layer. This means that cleaning and re-

applying between prints is recommended especially on longer prints or

challenging prints.

Storage and Handling:

Magigoo – Polypropylene should be stored in a cool dry place away from direct

sunlight. After use magigoo should be stored in an upright position and with

the cap

on.

Excess adhesive on the nib can cause the applicator adhering to the cap. To

prevent this, make sure no excess Magigoo remains on the rim of the

applicator after use.

Known Hazards:

Causes serious eye damage Wash hands and exposed skin thoroughly after handling.

Wear protective gloves.

Incompatible materials: Iron, Copper, Zinc.

Please refer to the SDS for full safety information.

2