LM358QT datasheet(5/25 Pages) STMICROELECTRONICS

5 / 25 page

LM158, LM258, LM358, LM158A, LM258A,

LM358A

Absolute maximum ratings

DocID2163 Rev 15

5/25

Absolute maximum ratings

Table 1: Absolute maximum ratings

Symbol

Parameter

LM158,A

LM258,A

LM358,A

Unit

VCC

Supply voltage

±16 or 32

Input voltage

-0.3 to 32

Vid

Differential input voltage

±32

Output short-circuit duration (1)

Infinite

Iin

Input current (2)

5 mA in DC or 50 mA in AC

(duty cycle = 10 %, T = 1 s)

Toper

Operating free-air temperature range

-55 to 125

-40 to 105

0 to 70

°C

Tstg

Storage temperature range

-65 to 150

Maximum junction temperature

150

Rthja

Thermal resistance junction to ambient

(3)

SO8

125

°C/W

MiniSO8

190

DFN8 2x2

TSSOP8

120

Rthjc

Thermal resistance junction to case (3)

SO8

MiniSO8

TSSOP8

ESD

HBM: human body model (4)

300

MM: machine model (5)

200

CDM: charged device model (6)

1.5

Notes:

(1)Short-circuits from the output to VCC can cause excessive heating if VCC > 15 V. The maximum output current is approximately

40 mA independent of the magnitude of VCC. Destructive dissipation can result from simultaneous short circuits on all amplifiers.

(2)This input current only exists when the voltage at any of the input leads is driven negative. It is due to the collector-base junction

of the input PNP transistor becoming forward-biased and thereby acting as input diode clamp. In addition to this diode action,

there is NPN parasitic action on the IC chip. This transistor action can cause the output voltages of the op amps to go to the VCC

voltage level (or to ground for a large overdrive) for the time during which an input is driven negative. This is not destructive and

normal output is restored for input voltages above -0.3 V.

(3)Short-circuits can cause excessive heating and destructive dissipation. Rth are typical values.

(4)Human body model: a 100 pF capacitor is charged to the specified voltage, then discharged through a 1.5 kΩ resistor between

two pins of the device. This is done for all couples of connected pin combinations while the other pins are floating.

(5)Machine model: a 200 pF capacitor is charged to the specified voltage, then discharged directly between two pins of the device

with no external series resistor (internal resistor < 5

Ω). This is done for all couples of connected pin combinations while the other

pins are floating.

(6)Charged device model: all pins and the package are charged together to the specified voltage and then discharged directly to

the ground through only one pin. This is done for all pins.

LM358QT 数据表(PDF) 5 Page - STMicroelectronics

LM358QT 数据表(HTML) 5 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25

数据表下载