8 Parameter Measurement Information

8.1 Solder Heat Shift

The materials used in the manufacture of the REF70 have differing coefficients of thermal expansion, resulting

in stress on the device die when the part is heated during soldering process. Mechanical and thermal stress on

the device die can cause the output voltages to shift, degrading the initial accuracy specifications of the product.

Reflow soldering is a common cause of this error. In order to illustrate this effect, a total of 32 devices were

soldered on two printed circuit boards [16 devices on each printed circuit board (PCB)] using lead-free solder

paste and the paste manufacturer suggested reflow profile. The reflow profile is as shown in Figure 8-1. The

printed circuit board is comprised of FR4 material. The board thickness is 1.65 mm and the area is 114 mm ×

152 mm.

For recommended reflow profiles using 'Sn-Pb Eutectic Assembly' or 'Pb-Free Assembly' please refer JEDEC

J-STD-020 standard.

0

50

100

150

200

250

300

0

50

100

150

200

250

300

350

400

Time (seconds)

C01

Figure 8-1. Reflow Profile

The reference output voltage is measured before and after the reflow process. Although all tested units exhibit

very low shifts, higher shifts are also possible depending on the size, thickness, and material of the printed circuit

board. An important note is that the Figure 8-2 display the typical shift for exposure to a single reflow profile.

Exposure to multiple reflows, as is common on PCBs with surface-mount components on both sides, causes

additional shifts in the output bias voltage. If the PCB is exposed to multiple reflows, the device must be soldered

in the last pass to minimize its exposure to thermal stress.

Solder Shift (%)

0

20%

40%

60%

80%

0

0.01

0.02

0.03

0.04

0.05

Figure 8-2. Solder Shift

www.ti.com

REF70

SNAS781E – OCTOBER 2020 – REVISED JULY 2022

Copyright © 2022 Texas Instruments Incorporated

Submit Document Feedback

17

Product Folder Links: REF70