User Manual

17 of 41

Revision 1.6

2019-07-16

EVAL-M3-102T User Manual

iMOTION™ Modular Application Design Kit

Getting Started with EVAL-M3-102T

iMOTION™ MADK system enables users to easily test different combination of control and power board with

their motors. User should be familiar with the system level parameters which are related to the motor used.

There is a very limited number of parameters which are specific to the control board or power board hardware.

Table 13 provides the MCEWizard setup overview for hardware related parameters. Similar tables will be

available in each power board’s User Manual. Combination of this table and the corresponding table of the

power board provides enough information to setup the MADK-based motor drive system in shortest time.

Table 13

MCEWizard setup overview table

Page

Parameter

Value

Comment

Welcome Page Power Board selecting

MADK power board name

If no, select similar

power board to modify

Options Page Motor 1 Shunt Configuration

Refer to the power board App Note

Question 3

Controller Supply Voltage

Refer to the power board App Note

VDD is 3.3V by default

Question 19

Max DC Bus Voltage

Refer to the power board App Note

Question 23

DC Bus Sensing High Resistor Refer to the power board App Note

Question 24

DC Bus Sensing Low Resistor

13.3 kOhm

Question 54

NTC Temperature Shutdown

value

Calculated as the Section 5.3.2

Refer to the power

board App Note

Question 63

GateSense Low-Side Devices

Refer to the power board App Note

High is true by default

Question 64

GateSense High-Side Devices Refer to the power board App Note

High is true by default

Question 69

Motor 1 Current Input

Calculated as the Section 5.1.2

Question 83

PFC Topology

Refer to the power board App Note

Boost or Totem-Pole

Question 85

PFC Current Input

Calculated as the Section 5.2.2

Question 92

PFC Gate Driver Polarity High

Side

Refer to the power board App Note

High is true by default

Question 93

PFC Gate Driver Polarity Low

Side

Refer to the power board App Note

High is true by default