TLD4012 datasheet(3/13 Pages) TRIPATH

3 / 13 page

Tr i p ath Technol ogy, I n c. - Techni cal I n for m ati on

TLD4012 – JB/Rev. 2.0a/05.02

ABSOLUTE MAXIMUM RATINGS

SYMBOL

PARAMETER

Value

UNITS

VDD5

Positive 5V Supply Voltage

+ 6

VSS5

Negative 5V Supply Voltage

- 6

VDD15

Positive 15V Supply Voltage

+ 18

VSS15

Negative 15V Supply Voltage

- 18

Maximum Junction Temperature

150

ºC

Operating Free-air Temperature Range

-40 to +85

ºC

TSTORE

Storage Temperature Range

-55 to 150

ºC

TSOLDER

Manual soldering for three seconds

Reflow soldering for five seconds

350

245

ºC

IOUT

Output current limit, OUTP or OUTN

1.1

VIN

Input voltage, INP or INN

VSS5 to VDD5

VCMR

Common mode input voltage range

VSS5 to VDD5

Notes:

1. Absolute Maximum Ratings indicate limits beyond which damage to the device may occur.

2. The absolute value of VDD5 and VSS5 must always be less than or equal to the absolute value of VDD15 and

VSS15.

3. The TLD4012 incorporates an exposed die pad on the underside of its package. This acts as a heat sink

and must be connected to a copper plane on the printed circuit board for proper heat dissipation.

Failure to do so may result in exceeding the maximum junction temperature which could permanently

damage the device. This copper plane must be connected to VSS15. See the Application Information

section of this document for additional information.

4. Application must insure that VSS15 is applied before VSS5. A clamp diode connected between VSS5 and

VSS15 can be used to insure proper application of supply voltages to the TLD4012 (see Test/Application

Circuits of this document). Note that only one diode is needed per board for multi-channel line cards, but diode

selection should account for the increased current transient that the diode must carry for multiple channels. If

the +/-5V rail’s rise time is fast, for example in applications in which the driver’s supplies might be hot-plugged,

this method may not be sufficient and supply sequencing may be necessary.

RECOMMENDED OPERATING CONDITIONS

SYMBOL

PARAMETER

MIN.

TYP.

MAX.

UNITS

VDD5

Positive 5V Supply Voltage

+ 4.75

+ 5

+ 5.25

VSS5

Negative 5V Supply Voltage

- 5.25

- 5

- 4.75

VDD15

Positive 15V Supply Voltage

+ 13.3

+ 15

+ 15.75

VSS15

Negative 15V Supply Voltage

- 15.75

- 15

- 13.3

VIH

High-level Input Voltage, all digital inputs

2.7

+VDD5

VIL

Low-level Input Voltage, all digital inputs

0.8

IODLEAK

Open drain leakage current, FAULT output

µA

IODMAX

Open drain sink current at VOL=0.4V max, FAULT output

Note: Recommended Operating Conditions indicate conditions for which the device is functional. See Electrical

Characteristics for guaranteed specific performance limits.

TLD4012 数据表(PDF) 3 Page - Tripath Technology Inc.

TLD4012 数据表(HTML) 3 Page - Tripath Technology Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13

数据表下载