Lumics GmbH Berlin. This specification is subject to change without notice.

User Safety

VISIBLE AND INVISIBLE LASER RADIATION

AVOID EYE OR SKIN EXPOSURE

TO DIRECT OR SCATTERED RADIATION

CLASS 4 LASER PRODUCT

IEC 60825-1 2007-3

AVOID EYE OR SKIN EXPOSURE TO

DIRECT OR SCATTERED RADIATION

OUTPUT POWER

WAVELENGTH

CLASS IV LASER PRODUCT

VISIBLE AND INVISIBLE LASER RADIATION

DANGER

280W

630 - 2000nm

280W

630 - 2000nm

Complies with 21 CFR1040.10

We manufacture diode lasers.

Member of

Group

Option: P2 water cooling base plate wih quick release water connectors and thermal resistance of 0.03 K/W.

Please note : Avoid to remove the water cooling plate from the P2 laser module because the optics is aligned with the water cooling

plate attached to the P2 module. If it is removed the housing might relax mechanically which move the fiber coupling port/nose

away from the focused light spot. Never change to a water cooling with a lower specifications regarding flatness

because this will bend the module and therefore lower fiber coupling efficiency.

Important Note Read and carefully follow operating manual instructions. Especially,

whenever power supply is switched on or off, always disconnect from laser module.

See manual for details. Uncontrolled on / off switching may cause spikes and result

in fatal device damage. This product is not certified by with IEC 60825-1 or 21CFR1040.10/

21CFR1040.11 and and must comply with the applicable regulations by the Purchaser

if sold as laser product.

Absolute Maximum Ratings / General Informations

Parameter

Symbol

Min

Max

Unit

Storage temperature

Tmax

0

+50

°C

Operating temp.* c.w.-operation **

Top c.w.

+15

+35

°C

Humidity / non condensing atmosphere

90

%

Recommended thermal heatsink resistance Rth

0.03

K/W

Max fiber flange temperature

45

°C

Max. back reflection of intrinsic pump wavelength output power

10

%

Max. back reflection any other than l of this diode laser

10

µJ

Compliance

CE, ROHS

Standard Accessories

Interface connector

13w3 Female

Mounting screws / metric

8 x M4 x 12

mm

Remarks

* taken at internal temperature sensor

** we recommend to operate the laser above dew point