WD 1 (M) / WD 1000 (M)

11-18

Setting temperature deactivation (SETBACK)

When the soldering tool is not in use, the temperature is reduced to

the standby temperature after the set setback time has elapsed. The

setback state is indicated by a flashing actual value and "STANDBY“

appears in the display. Pressing the UP or DOWN button terminates

this setback state. Depending on the tool, the finger switch or the

switching holder deactivates the setback state.

The following setback settings are possible:

−

"0 min“: setback OFF (factory setting)

−

"ON“: setback ON (the system is controlled down to standby

temperature with the switching holder after the soldering bit is

stowed)

−

"1-99 min“: setback ON (individually settable setback time)

1. Select the menu item SETBACK in Menu 1.

2. Set the setback value with the UP or DOWN button.

3. Press the I (back) or II (forwards) button to switch to the next

menu item.

Note In the case of soldering work with low heat requirements, the

reliability of the Setback function may be impaired.

Setting the automatic switch-off time (AUTO-OFF)

When the soldering tool is not in use, heating of the soldering

tool is switched off after the AUTO-OFF time has elapsed.

Temperature deactivation is performed independently of the set

setback function. The actual temperature flashes in the display and

serves as residual-heat indicator. "OFF“ appears in the display. A

flashing dash appears in the display below 50 °C (150 °F).

The following AUTO-OFF time settings are possible:

−

"0 min“: AUTO-OFF function is switched off

−

"1-999 min“: AUTO-OFF time, individually settable

1. Select the menu item OFF in Menu 1.

2. Set the AUTO-OFF setpoint time value with the UP or DOWN

button.

3. Press the I (back) or II (forwards) button to switch to the next

menu item.

I

II

III

I

II

III