SPSB081 datasheet(27/135 Pages) STMICROELECTRONICS

27 / 135 page

Figure 17. Overvoltage detection V1 = 5 V

3.11

LIN bus interfaces (only for SPSB0815 and SPSB0813)

3.11.1

Features

•

LIN ISO 17987-4/2016 compliant transceiver

•

Designed according to SAE J2962-1 (draft nov. 2017)

•

Meet OEM hardware requirements for CAN and LIN FR-Interfaces (version 1.3 2012)

•

Data rate up to 20 kbit/s

•

GND disconnection fail-safe at module level

•

Off mode: does not disturb network

•

GND shift operation at system level

•

Microcontroller interface with CMOS compatible I/O pins

•

Internal pull-up resistor

•

Transients immunity and ESD according to ISO7637-2, ISO 62215-3 and EN / IEC 61000-4-2.

•

Matched output slopes and propagation delay

•

Wake up behavior according to LIN2.2a and ‘Hardware requirements for LIN, CAN and Flexray interfaces

(version 1.3)

At VSREG > Vpor (that is, VSREG power-on reset threshold), the LIN transceiver is enabled.

The LIN transmitter is disabled in case of the following errors:

•

Dominant TxD_L time out

•

LIN permanent recessive

•

Thermal shutdown 1

–

with thermal sensor “Global” in mode “no cluster”

or with thermal sensor “Th_CL4” in mode “cluster”

•

VSREG overvoltage / undervoltage

•

V1 undervoltage

The LIN receiver is not disabled in case of any failure condition.

(it is reactivated in case of FS by thermal shutdown)

SPSB081

LIN bus interfaces (only for SPSB0815 and SPSB0813)

DS14048 - Rev 1

page 27/135

SPSB081 数据表(PDF) 27 Page - STMicroelectronics

SPSB081 数据表(HTML) 27 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载