76232103 datasheet(10/70 Pages) TOSHIBA

10 / 70 page

– 10 –

WIDTH

(WID)

E-W PARABOLA

(PARA)

WHITE BALANCE

ADJUSTMENT

• CUTOFF ADJUSTMENT

(RCUT)

(GCUT)

(BCUT)

• DRIVE ADJUSTMENT

(GDRV)

(BDRV)

1. Call up the adjustment mode display, then select the item WID.

2. Press the ; – /+ button to get the picture so the left and rightedges of raster begins

to lack.

3. Press the ; – /+ button to advance the data by 7 steps.

Note: Check the horizontal picture position is correct.

1. Call up the adjustment mode display, then select the item PARA.

2. Press the a button on Remote until the cross-hatch pattern appears on the screen.

3. Press the ; – /+ button to make vertical lines straight as shown below.

1. Set Contrast to 40, and brightness to +20 by picture control.

2. Receive the Black and White pattern.

3. Select RCUT, GCUT, BCUT, GDRV and BDRV with CH s, t buttons. Press volume

; – /+ buttons to set individual values to initial reference data.

4. Press

button on the remote control and rotate Screen VR to get one slight

horizontal line on screen.

Note: Every pressing of

button provides Horizontal line picture and Normal

picture alternately.

5. Press

button to release horizontal line picture, and select the two other colors

which did not light in the above step with CH s, t buttons. Then tap ; – /+ buttons

so that three colors slightly light in the same level.

X To correct white balance in light area,

select GDRV and BDRV with CH s, t

buttons to adjust.

X To correct white balance in dark area,

perform fine adjustment of RCUT, GCUT

and BCUT.

ITEM

ADJUSTMENT PROCEDURE

Light area check

(to show white)

Dark area check

(to show black)

76232103 数据表(PDF) 10 Page - Toshiba Semiconductor

76232103 数据表(HTML) 10 Page - Toshiba Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70

数据表下载