24232103 datasheet(70/126 Pages) TOSHIBA

70 / 126 page

SCHEMATIC DIAGRAM

MODEL : 40PW03G / 40PW03B

CAUTION: The international hazard symbols "*" in the schematic diagram and the parts list designate components

which have special characteristics important for safety and should be replaced only with types identical to those in the

original circuit or specified in the parts list. The mounting position of replacements is to be identical with originals.

Before replacing any of these components, read carefully the PRODUCT SAFETY NOTICE on the MANUAL for this

model. Do not degrade the safety of the receiver through improper servicing.

CBSERVATION OF VOLTAGES AND WAVEFORMS

1. Voltages read with VTVM from point shown to chassis ground, line voltage 220 volts, colour bar signal. Voltages

reading may vary

±20%.

2. All waveforms are taken using a wide band oscilloscope and a low capacity probe.

3. Waveforms are taken using a standard colour bar signal.

4. Make sure that CONTRAST and COLOUR controls are in mid position and BRIGHTNESS control is almost in

maximum position. Set other controls for best picture.

NOTES:

1. D.C. resistance value of a principal transformer is shown in this schematic diagram. These are measured for

separated from the circuit.

2. The circuits are subject to change without notice.

: Solder links.

EXPRESSION

VALUE OF RESISTOR, CAPACITOR and INDUCTOR

1. Resistance is shown in ohm, K=1,000, M=1,000,000

2. Unless other wise noted in schematic, all capacitor values less than 1 are expressed in ?F and the values more

than 1 in pF.

3. Unless other wise noted in schematic, all inductor values more than 1 are expressed in ?H, and the values less

than 1 in H.

24232103 数据表(PDF) 70 Page - Toshiba Semiconductor