AS5600-ASOM datasheet(11/44 Pages) OSRAM

11 / 44 page

Page 10

ams Datasheet

Document Feedback

[v1-06] 2018-Jun-20

AS5600 − Detailed Description

I²C Interface

The AS5600 supports the 2-wire Fast-mode Plus I²C-slave

protocol in device mode, in compliance with the NXP

Semiconductors (formerly Philips Semiconductors)

specification UM10204. A device that sends data onto the bus

is a transmitter and a device receiving data is a receiver. The

device that controls the message is called a master. The devices

that are controlled by the master are called slaves. A master

device generates the serial clock (SCL), controls the bus access,

and generates the START and STOP conditions that control the

bus. The AS5600 always operates as a slave on the I²C bus.

Connections to the bus are made through the open-drain I/O

lines SDA and the input SCL. Clock stretching is not included.

The host MCU (master) initiates data transfers. The 7-bit slave

address of the AS5600 is 0x36 (0110110 in binary).

Supported Modes

• Random/Sequential read

• Byte/Page write

• Automatic increment (ANGLE register)

• Standard-mode

• Fast-mode

• Fast–mode plus

The SDA signal is the bidirectional data line. The SCL signal is

the clock generated by the I²C bus master to synchronize

sampling data from SDA. The maximum SCL frequency is 1 MHz.

Data is sampled on the rising edge of SCL.

I²C Interface Operation

Figure 14:

I²C Timing Diagram

SDA

SCL

Start

Stop

tbuf

tLOW tR

tHD.STA

tHIGH

tSU.DAT

tSU.STA

tHD.STA

tSU.STO

Repeated

Start

tHD.DAT

AS5600-ASOM 数据表(PDF) 11 Page - OSRAM GmbH

AS5600-ASOM 数据表(HTML) 11 Page - OSRAM GmbH

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

数据表下载