3

Absolute maximum ratings and operating conditions

Table 1. Absolute maximum ratings (AMR)

Symbol

Parameter

Value

Unit

VCC

Supply voltage (1)

± 16 to 32

V

Vid

Differential input voltage (2)

32

Vin

Input voltage

-0.3 to 32

Output short-circuit duration (3)

Infinite

s

Tj

Maximum junction temperature

150

° C

Tstg

Storage temperature range

-65 to 150

Iin

Input current : Vin driven negative (4)

5 in DC or 50 in AC (duty cycle = 10 %, T = 1 s)

mA

Input current : Vin driven positive above AMR value (5)

0.4

Rthja

Thermal resistance junction-to-ambient (6)

SO14

105

° C/W

TSSOP14

100

QFN16 3x3

45

Rthjc

Thermal resistance junction-to-case

SO14

31

TSSOP14

32

QFN16 3x3

14

ESD

HBM: human body model (7)

370

V

MM: machine model (8)

150

CDM: charged device model (9)

1500

1. All voltage values, except the differential voltage are with respect to the network ground terminal.

2. Differential voltages are the non-inverting input terminal with respect to the inverting input terminal.

3. Short-circuits from the output to VCC + can cause excessive heating and eventual destruction. The maximum output current is approximately

20 mA, independent of the magnitude of VCC +.

4. This input current only exists when the voltage at any of the input leads is driven negative. It is due to the collector-base junction of the

input PNP transistor becoming forward-biased and thereby acting as an input diode clamp. In addition to this diode action, there is an NPN

parasitic action on the IC chip. This transistor action can cause the output voltages of the op amps to go to the VCC voltage level (or to

ground for a large overdrive) for the time during which an input is driven negative. This is not destructive and normal output is restored for

input voltages above -0.3 V.

5. The junction base/substrate of the input PNP transistor polarized in reverse must be protected by a resistor in series with the inputs to limit

the input current to 400 µ A max (R = (Vin - 36 V)/400 µ A).

6. Rthja/c are typical values.

7. Human body model: a 100 pF capacitor is charged to the specified voltage, then discharged through a 1.5 kΩ resistor between two pins of

the device. This is done for all couples of connected pin combinations while the other pins are floating.

8. Machine model: a 200 pF capacitor is charged to the specified voltage, then discharged directly between two pins of the device with no

external series resistor (internal resistor < 5 Ω). This is done for all couples of connected pin combinations while the other pins are floating.

9. Charged device model: all pins and the package are charged together to the specified voltage and then discharged directly to the ground

through only one pin. This is done for all pins.

Table 2. Operating conditions

Symbol

Parameter

Value

Unit

VCC

Supply voltage

3 to 30

V

Vicm

Common mode input voltage range

(VCC +) - 1.5

Tmin ≤ Tamb ≤ Tmax

(VCC +) - 2

Toper

Operating free-air temperature range

-40 to 125

° C

LM2902

Absolute maximum ratings and operating conditions

DS0506 - Rev 9

page 4/20