AP2014/A

SYNCHRONOUS PWM DC-DC BUCK CONTROLLER

DS30883 Rev. 1 - 0

1 of 13

AP2014/A

www.diodes.com

•

Synchronous PWM DC-DC Controller in an 8-Pin

Package

•

Operating with single 5V or 12V supply voltage

•

Internal 200KHz Oscillator (400KHz for AP2014A)

•

Soft-Start Function

•

Fixed Frequency Voltage Mode

•

500mA Peak Output Drive Capability

•

Output protected when control FET is shorted

•

SOP-8L Pb-Free and Green (under development)

packages

The AP2014 PWM DC-DC controller IC is designed to provide a

low cost synchronous Buck regulator for on-board DC to DC

converter applications. With the migration of today’s ASIC

products requiring low supply voltages such as 1.8V and lower,

together with currents in excess of 3A, traditional linear regulators

are simply too lossy to be used when input supply is 5V or even

in some cases with 3.3V input supply. The AP2014 together with

dual N-channel MOSFETs such as AF9410, provide a low cost

solution for such applications. This device features an internal

200KHz oscillator (400KHz for "A" version), under-voltage

lockout for both Vcc and Vc supplies, an external programmable

soft-start function as well as output under-voltage detection that

latches off the device when an output short is detected.

•

Graphic Card

•

Hard Disk Drive

•

DDR memory source sink Vtt application

•

Low cost on-board DC to DC such as 5V to 3.3V, 2.5V or 1.8V

SOP-8L

1

2

3

45

6

7

8

(Top View)

Vcc

GND

AP2014/A

LDrv

HDrv

Vc

Comp

FB

SS

Features

General Description

Applications

Pin Assignments