P13L

www.vishay.com

Vishay Sfernice

Revision: 30-Jul-2021

4

Document Number: 51065

For technical questions, contact: sferpottrimmers@vishay.com

THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT

ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000

Shaft locking

On potentiometers equipped with a 3 mm Ø shaft, shaft locking can be obtained:

• Either by a taper nut tightening a slotted bushing. Ask for P13LO type. These devices are normally

equipped with an AB type shaft (12.5 mm with a slot).

P13LO

• Or by a tightening nut locked by a screw. Ask for ES1 type. On potentiometers equipped with a

Ø 6 mm shaft, locking can be obtained by a taper nut applying pressure on a slotted notched washer.

This device is supplied in a box as an accessory. Ask for DBAN.

These devices are ordered separately. Please consult Vishay Sfernice.

P13LL DBAN

No locking on shaft Ø 4 mm.

MARKING

Printed:

• Vishay trademark

• Part number (including ohmic value code, tolerance code and taper)

• Manufacturing date code

• Marking of terminals a

APPLICATION NOTE

The potentiometer shall be used in voltage divider with an impedance load at least

100 times higher than the total potentiometer nominal resistance value.

Advised load impedance:

1 M

Ω min. for resistance range of 1 kΩ to 50 kΩ

PACKAGING

• In box of 8 pieces for shafts FR and FQ

• In box of 10 pieces for shafts FE, FL, FG, and FK

• In box of 15 pieces for shafts AJ and EJ

• In box of 25 pieces for shafts AB, AA, EA, and EB

Hardware: nuts, washer, and O-ring are separately supplied (not mounted on the potentiometer), in a small bag placed in the packaging.

OPTIONS

0.7

10 wrench

Slotted bushing

Thread M6 x 0.75

8 wrench

11

Ø 3

AB = 12.5

12 wrench

6.5

(1) a

(2) b

c (3)

cw

V

out

V

in

Z >

1 M

Ω