TOP261YN-TL datasheet(2/50 Pages) POWERINT

2 / 50 page

Rev. M 12/21

TOP252-262

www.power.com

EcoSmart™– Energy Efficient

•

Energy efficient over entire load range

•

No-load consumption

•

Less than 200 mW at 230 VAC

•

Standby power for 1 W input

•

>600 mW output at 110 VAC input

•

>500 mW output at 265 VAC input

Description

TOPSwitch™-HX cost effectively incorporates a 700 V power

MOSFET, high voltage switched current source, PWM control,

oscillator, thermal shutdown circuit, fault protection and other

control circuitry onto a monolithic device.

Figure 2.

Typical Flyback Application TOP259YN, TOP260YN and TOP261YN.

Y Package Option for TOP259-261

In order to improve noise-immunity on large TOPSwitch-HX

Y package parts, the F pin has been removed (TOP259-261YN

are fixed at 66 kHz switching frequency) and replaced with a

SIGNAL GROUND (G) pin. This pin acts as a low noise path for

the C pin capacitor and the X pin resistor. It is only required for

the TOP259-261YN package parts.

Notes for Table 1:

1. Minimum continuous power in a typical non-ventilated

enclosed adapter measured at +50 °C ambient. Use of an

external heat sink will increase power capability.

2. Minimum continuous power in an open frame design at

+50 °C ambient.

3. Peak power capability in any design at +50 °C ambient.

4. 230 VAC or 110/115 VAC with doubler.

5. Packages: P: DIP-8C, G: SMD-8C, M: SDIP-10C,

Y: TO-220-7C, E: eSIP-7C, L: eSIP-7F.

See part ordering information.

6. TOP261 and TOP262 have the same current limit set point. In

some applications TOP262 may run cooler than TOP261 due

to a lower R

DS(ON) for the larger device.

PI-4973-122607

OUT

TOPSwitch-HX

CONTROL

TOP261YN-TL 数据表(PDF) 2 Page - Power Integrations, Inc.

TOP261YN-TL 数据表(HTML) 2 Page - Power Integrations, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50

数据表下载