TSOP581.., TSOP583.., TSOP585..

www.vishay.com

Vishay Semiconductors

Rev. 1.8, 21-Apr-2022

1

Document Number: 82462

THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT

ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000

IR Receiver Modules for Remote Control Systems

LINKS TO ADDITIONAL RESOURCES

DESCRIPTION

These products are miniaturized receivers for infrared

remote control systems. A PIN diode and a preamplifier are

assembled on a lead frame, the epoxy package contains an

IR filter. The demodulated output signal can be directly

connected to a microprocessor for decoding.

The TSOP583.. series devices are optimized to suppress

almost all spurious pulses from Wi-Fi and CFL sources.

They may suppress some data signals if continuously

transmitted.

The TSOP581.. series devices are provided primarily for

compatibility with old AGC1 designs. New designs should

prefer the TSOP583.. series containing the newer AGC3.

The TSOP585.. series are useful to suppress even extreme

levels of optical noise, but may also suppress some data

signals. Please check compatibility with your codes.

These components have not been qualified according to

automotive specifications.

FEATURES

• Improved immunity against HF and RF noise

• Low supply current

• Photo detector and preamplifier in one package

• Internal filter for PCM frequency

• Improved shielding against EMI

• Supply voltage: 2.5 V to 5.5 V

• Suitable for short bursts: burst length

≥ 6 carrier

cycles

• Improved immunity against ambient light

• Insensitive to supply voltage ripple and noise

• Material categorization: for definitions of compliance

please see www.vishay.com/doc?99912

MECHANICAL DATA

Pinning for TSOP581.., TSOP583.., TSOP585:

1 = OUT, 2 = GND, 3 = VS

ORDERING CODE

TSOP58... - 1500 pieces in bags

BLOCK DIAGRAM

APPLICATION CIRCUIT

19026

1

2

3

2

3

Product Page

333

DDD3 D

3D Models

Calculators

Marking

Packages

Holders

Bends and Cuts

33 k

Ω

2

3

1

Demo-

pass

AGC

Input

PIN

Band

dulator

Control circuit

16833_14

C1

IR receiver

GND

μC

R1

+ VS

GND

Transmitter

with

TSALxxxx

VS

VO

17170-11

OUT

R

1 and C1 recommended to reduce supply ripple for VS < 2.8 V