VersaKit-30xx

When a breakpoint is set in the code, the breakpoint reference number will be displayed in red right next to the code line.

The breakpoint toolbar will then display the active breakpoint. Double clicking again on a given code line where a

breakpoint has been set will disable that breakpoint.

Figure 24: Setting Breakpoint by double clicking on a code line

Once a breakpoint is set, click on run . The processor will then start executing code at full speed until a breakpoint is

reached or halted

.

Figure 25: Breakpoint reached

_______________________________________________________________________________________________

www.ramtron.com

page 21 of 28