M29F032D datasheet(5/35 Pages) STMICROELECTRONICS

5 / 35 page

5/35

M29F032D

SUMMARY DESCRIPTION

The M29F032D is a 32 Mbit (4Mb x8) non-volatile

memory that can be read, erased and repro-

grammed. These operations can be performed us-

ing a single low voltage 5V supply. On power-up

the memory defaults to its Read mode where it can

be read in the same way as a ROM or EPROM.

The memory is divided into 64 uniform blocks of

64Kbytes (see Figure 5, Block Addresses) that

can be erased independently so it is possible to

preserve valid data while old data is erased.

Blocks can be protected in groups of 4 to prevent

accidental Program or Erase commands from

modifying the memory. Program and Erase com-

mands are written to the Command Interface of

the memory. An on-chip Program/Erase Controller

simplifies the process of programming or erasing

the memory by taking care of all of the special op-

erations that are required to update the memory

contents. The end of a program or erase operation

can be detected and any error conditions identi-

fied. The command set required to control the

memory is consistent with JEDEC standards.

Chip Enable, Output Enable and Write Enable sig-

nals control the bus operation of the memory.

They allow simple connection to most micropro-

cessors, often without additional logic.

The memory is delivered with all the bits erased (set

to 1).

Figure 2. Logic Diagram

Table 1. Signal Names

AI05258

A0-A21

DQ0-DQ7

VCC

M29F032D

VSS

A0-A21

Address Inputs

DQ0-DQ7

Data Inputs/Outputs

Chip Enable

Output Enable

Write Enable

Reset/Block Temporary Unprotect

Ready/Busy Output

VCC

Supply Voltage

VSS

Ground

Not Connected Internally

M29F032D 数据表(PDF) 5 Page - STMicroelectronics

M29F032D 数据表(HTML) 5 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35

数据表下载