| 数据搜索系统,热门电子元器件搜索 |
|
STEF12E 数据表(PDF) 8 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
STEF12E 数据表(HTML) 8 Page - STMicroelectronics |
|
8 / 19 page ![]() Figure 5. Delay time and VOUT ramp-up time 0 2 4 6 8 10 12 Time En/fault VOUT delay time ramp -up time AMG300320171104MT 6.8 En/fault pin The En/fault pin has the dual function to control the output of the device and, at the same time, provide the application with information about the device status. When it is used as a standard enable pin, it should be connected to an external open-drain or open-collector device. In this case, when it is pulled to low logic level, it turns the output of the E-Fuse off. If this pin is left floating, since it has an internal pull-up circuitry, the output of the E-Fuse is kept on, in normal operating conditions. In case of thermal fault, the pin is pulled to an intermediate state (Figure 6. En/fault pin status). This signal can be provided to a monitor circuit, informing it that a thermal shutdown has occurred, or it can be directly connected to the Enable/fault pin of the other STEFxx devices on the same application in order to achieve a simultaneous enable/disable feature. When a thermal fault occurs, the device can be reset either by cycling the supply voltage or by pulling down the Enable pin below the VIL threshold and then releasing it. Figure 6. En/fault pin status STEF12E En/fault pin DS12800 - Rev 2 page 8/19 |
|
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |