69

www.ittcannon.com

Dimensions shown in inch (mm)

Specifications and dimensions subject to change

The Centi Line - .075" Contact Spacing

2D/CTA

CTA Assembly Instructions

.275 (6.98)

MAX.

.475 (12.06)

MAX.

INSERTION

Guide Posts

Polarizing Posts

1. Place the connector into the slot in the assembly block

with the arrows on the insulator pointing downward. The

connector will bottom against the internal shoulder in the

groove in the assembly block. Start contact insertion by

placing the crimped contact in the cavity by hard.

3. With firm steady pressure, push the contact into the

cavity until the resilient internal shoulder snaps into the

locking groove in the contact. To prevent over insertion,

the tool tip bottoms against the rear of the insulator.

4. The guide post and polarizing posts are inserted in teh

same manner as the contacts. The guide posts are inserted

into the socket insulator, and the polarizing posts are

inserted into the pin insulartor. The corresponding contact

in the mating insulator must be removed for each.

2. Position the insertion tool tip on the rear of contact as

shown. The insulation must be pulled back from the crimp

pot approximately 1/32" to allow the tool tip to butt

against the contact crimp pot.

EXTRACTION

1. To extract the contacts, place the conector face up in

the assembly block so that the contact to be extracted is

in the end of the block that has a fully slotted opening.

2. The pin extraction tool tip is tubular, slides over the pin

bundle and butts against the front shoulder of the pin. The

socket extraction tool is a solid rod that fits into the socket

contact, the external shoulder butts against the contact

socket shoulder.

3. Insert the extraction tool into the cavity and apply firm

pressure until the contact is pushed thru the rear of the

connector.

4. Lift the insulator from the groove and pull the contact

out. Repeat for balance of contacts to be removed.