D90N03L datasheet(9/16 Pages) STMICROELECTRONICS

9 / 16 page

STD90N03L - STD90N03L-1

9/16

Appendix A

The power losses associated with the FETs in a Synchronous Buck converter can be

estimated using the equations shown in the table below. The formulas give a good

approximation, for the sake of performance comparison, of how different pairs of devices

affect the converter efficiency. However a very important parameter, the working

temperature, is not considered. The real device behavior is really dependent on how the

heat generated inside the devices is removed to allow for a safer working junction

temperature.

The low side (SW2) device requires:

■ Very low RDS(on) to reduce conduction losses

■ Small Qgls to reduce the gate charge losses

■ Small Coss to reduce losses due to output capacitance

■ Small Qrr to reduce losses on SW1 during its turn-on

■ The Cgd/Cgs ratio lower than Vth/Vgg ratio especially with low drain to source

■ voltage to avoid the cross conduction phenomenon;

The high side (SW1) device requires:

■ Small Rg and Ls to allow higher gate current peak and to limit the voltage feedback on the

gate

■ Small Qg to have a faster commutation and to reduce gate charge losses

■ Low RDS(on) to reduce the conduction losses.

Figure 16. Buck Converter: Power Losses Estimation

D90N03L 数据表(PDF) 9 Page - STMicroelectronics