HORNET PRO

DS-HORNETPRO-3

Pairing a transmitter button using the LEARN switch option

(12-30Vac-dc Receiver only)

To pair a new transmitter switch follow this procedure:

Unscrew the antenna, Open the enclosure, and extract the Circuit-board as-

sembly

1.

Briefly press the receiver LEARN switch once

2.

The Learn LED will flash once (One flash means the receiver unit is ready

to allocate a transmitter to relay output 1)

3.

To select relay output 2, 3 or 4, briefly press the LEARN switch again and

repeat until the LED flashes 2, 3 or 4 times. The LED will flash the correct

number of times to indicate which Relay output is selected.

4.

Press the button on the transmitter you want to learn to the chosen relay.

5.

The Learn LED will flash to indicate Pairing is complete.

Maximum Number of Transmitters to a Receiver

Each receiver has a maximum memory for up to 30 pairings, these can be

from the same or any number of transmitters.

Erasing Receivers Memory

1.

Press and hold the receiver Learn Switch for ~5 seconds.

2.

The receiver will sound a long Beep to confirm erased.

NOTE: You cannot erase individual Tx encoders

LEARN Switch

Advanced operation - Pairing a transmitter button with a magnet

With this system, you can pair together any individual transmitter switch

with any receiver relay switch. Without opening either enclosure:

1.

Briefly (less than 1 second) place a magnet next to the receiver in

the position shown and then remove it.

2.

The receiver will buzz once (One buzz means the receiver unit is

ready to allocate a transmitter button to relay output 1)To select

relay output 2, 3 o 4, briefly place the magnet again so that the

Buzzer Buzzes to indicate the Relay output 2,3, or 4.

3.

Press the switch on the transmitter which you wish to pair

4.

The receiver will buzz twice to confirm pairing

5.

Repeat for any additional transmitter switches