Document Feedback

TMF882X

Setting Up the EVM

Demo Kit Manual

• PUBLIC

UG000495

• v6-00 • 2022-May-19

36

│ 5

2

Setting Up the EVM

This section describes the setup steps necessary to start using the EVM software.

2.1

Setting Up the EVM Hardware

The ToF sensor enclosure is already assembled and ready to plug in to a PC. The EVM with the

enclosure exposes only one micro-USB connector:

Figure 2:

EVM with Enclosure

On EVMs without enclosure (or if the enclosure has been removed) plug in the micro-USB connector

to the USB connector closer to the center of the Raspberry PI Zero W board (see Figure 3)