ADM1192

Rev. 0 | Page 13 of 20

WRITE EXTENDED BYTE

In the write extended byte operation, the master device writes

to one of the three extended registers of the slave device, as follows:

1.

The master device asserts a start condition on SDA.

2.

The master sends the 7-bit slave address, followed by the

write bit (low).

3.

The addressed slave device asserts an acknowledge on SDA.

4.

The master sends the register address byte. The MSB of this

byte is set to 1 to indicate an extended register write. The two

LSBs indicate which of the three extended registers are to be

written to (see Table 8). All other bits should be set to 0.

5.

The slave asserts an acknowledge on SDA.

6.

The master sends the command byte. The command byte

is identified by an MSB = 0. An MSB = 1 indicates an

extended register write.

7.

The slave asserts an acknowledge on SDA.

8.

The master asserts a stop condition on SDA to end the

transaction.

S

SLAVE

ADDRESS

WA

REGISTER

ADDRESS

AP

REGISTER

DATA

A

12

3

4

5

6

7 8

Figure 23. Write Extended Byte

Table 9, Table 10, and Table 11 give details of each extended

register.

Table 8. Extended Register Addresses

A6

A5

A4

A3

A2

A1

A0

Extended Register

0

0

0

0

0

0

1

ALERT_EN

0

0

0

0

0

1

0

ALERT_TH

0

0

0

0

0

1

1

CONTROL

Table 9. ALERT_EN Register Operations

Bit

Default

Name

Function

0

0

EN_ADC_OC1

Enabled if a single ADC conversion on the I channel has exceeded the threshold set in the ALERT_TH

register.

1

0

EN_ADC_OC4

Enabled if four consecutive ADC conversions on the I channel have exceeded the threshold set in the

ALERT_TH register.

2

1

EN_OC_ALERT

Enables the OC_ALERT register. If an overcurrent condition is present and the TIMER pin has charged to

1.3 V, the OC_ALERT register captures and latches this condition.

3

0

EN_OFF_ALERT

Enables an alert if the HS operation is turned off by an operation that writes the SWOFF bit high. This

allows software override of the ALERT output and turns on a P-channel FET controlled by ALERT.

4

0

CLEAR

Clears the OC_ALERT and ADC_ALERT status bits in the status register. These may immediately reset if

the source of the alert has not been cleared or disabled with the other bits in this register. This bit self-

clears to 0 after the status register bits have been cleared.

Table 10. ALERT_TH Register Operations

Bit

Default

Function

7:0

FF

The ALERT_TH register sets the current level at which an alert occurs. Defaults to ADC full scale. The ALERT_TH 8-bit

number corresponds to the top eight bits of the current channel data.

Table 11. CONTROL Register Operations

Bit

Default

Name

Function

0

0

SWOFF

Forces the ALERT pin to deassert. Can be active only if the EN_OFF_ALERT bit is high (see Table 9).