74LVC573A

Octal D-type transparent latch

with 5 V tolerant inputs/outputs; 3-state

Rev. 8 — 27 August 2021

Product data sheet

1. General description

The 74LVC573A is an 8-bit D-type transparent latch with 3-state outputs. The device features latch

enable (LE) and output enable (OE) inputs. When LE is HIGH, data at the inputs enter the latches.

In this condition the latches are transparent, a latch output will change each time its corresponding

D-input changes. When LE is LOW the latches store the information that was present at the inputs

a set-up time preceding the HIGH-to-LOW transition of LE. A HIGH on OE causes the outputs to

assume a high-impedance OFF-state. Operation of the OE input does not affect the state of the

latches. Inputs can be driven from either 3.3 V or 5 V devices. This feature allows the use of these

devices as translators in mixed 3.3 V and 5 V environments.

Schmitt-trigger action at all inputs makes the circuit tolerant of slower input rise and fall times.

This device is fully specified for partial power down applications using IOFF. The IOFF circuitry

disables the output, preventing the potentially damaging backflow current through the device when

it is powered down.

2. Features and benefits

• Wide supply voltage range from 1.2 to 3.6 V

• Overvoltage tolerant inputs to 5.5 V

• CMOS low power consumption

• Direct interface with TTL levels

• IOFF circuitry provides partial Power-down mode operation

• High-impedance when VCC = 0 V

• Flow-through pinout architecture

• Complies with JEDEC standard:

• JESD8-7A (1.65 V to 1.95 V)

• JESD8-5A (2.3 V to 2.7 V)

• JESD8-C/JESD36 (2.7 V to 3.6 V)

• ESD protection:

• HBM JESD22-A114F exceeds 2000 V

• MM JESD22-A115-B exceeds 200 V

• CDM JESD22-C101E exceeds 1000 V

• Specified from -40 °C to +85 °C and -40 °C to +125 °C