Page 2/6

Multicomponent Force Link Set, ø72 mm, –25 ... 60 kN, Type 9366CDsp

© 2023 Kistler Group,

Eulachstraße 22, 8408 Winterthur, Switzerland

Tel. +41 52 224 11 11, info@kistler.com, www.kistler.com. Kistler Group

products are protected by various intellectual property rights. For more details

visit www.kistler.com

This information corresponds to the current state of knowledge. Kistler reserves

the right to make technical changes. Liability for consequential damage resulting

from the use of Kistler products is excluded.

Assembly

The multicomponent force link set is first connected to the

4 sensor cables of the summing box and then mounted on

the prepared top plate fabricated as directed in the instruc-

tion manual. Four M12 Allen screws are then used to mount

the fully assembled force plate on a flat, clean base plate.

Uneven bearing surfaces induce internal stresses that substan-

tially increase the loading on the individual force links and can

increase crosstalk.

The four mounting holes in the top plate are sealed with a

protective lid (optional accessory).

Once the set has been correctly assembled, the force plate is

ready for immediate use without recalibration.

Dimensions

M12

M6

Top plate

Protective lid

Force link

Base plate

Fig.1: Mounting set Type 9366CDsp

ø72

8xM6

ø56

ø42

–0,05

–0,1

ø13

ø18,6

ø42

ø60

Cable length: l

ø5,3

Summing box

93x93x33 mm

Fischer flange 9-way neg.

67

76

Fig. 2: Dimensions of multicomponent force link set Type 9366CDsp