FIGURE 6

FIGURE 7

FIGURE 8

MOISTURE RESISTANCE LOADING

Capacitors shall be subjected to a temperature of 40±2 °C at 90 to 95% relative humidity

with rated voltage for 500 Hours. After the test the samples are maintained at normal

temperature and relative humidity for a period of 4 to 24 hours. When tested after this;

1. The capacitor samples shall be free of cracks, or other mechanical damages and the

marking shall remain legible

2. The samples shall meet the original requirement of the Withstanding voltage

3. The samples shall meet the after test requirement of Insulation resistance as furnished in

Figure 2

4. The dissipation factor shall be within 2 times the original limits

5. The capacitance change shall not exceed ±5% or ±1 pF

LIFE TEST

The capacitor samples shall be subjected to a temperature of

125 °C with 150% of rated

voltage for 2000 hours.

After the test :

1. The capacitor samples shall be free of cracks, or other mechanical damages and the

marking shall remain legible

2. The samples shall meet the original requirement of the

Withstanding voltage

3. The samples shall meet the original requirements of Insulation resistance as furnished in

Figure 1.

4. The dissipation factor shall be within 1.5 times the original limits

5. The capacitance change shall not exceed ±3% or ±1 pF(whichever is greater) for

characteristic "C" and ±2.5 ±1pF (whichever is greater) for characteristic D, E and F.)

OTHER TYPICAL VARIATION PATTERNS

Some typical variation patterns for selected values during heat resistance load life test and

moisture proof load life tests as listed below are illustrated in Figures 8 through 10.

1. Insulation resistance Vs. time for heat resistance load life test and moisture proof load life

tests (Figure 8).

2. Capacitance change in percentage Vs. time (Figure 9).

3. Dissipation factor Vs. time (Figure 10).

Other variation patterns and characteristic for selected values as listed below are furnished

as Figures 11 through 14

1. Capacitance change Vs. frequency (Figure 11)

2. Capacitance change Vs. time(Figure 12)

3. Dissipation factor change Vs. frequency(Figure 13)

4. Insulation resistance Vs. temperature (Figure 14)

FIGURE 9

FIGURE 10

FIGURE 11

FIGURE 12

FIGURE 13

FIGURE 14

Sharma Mica Capacitors

Page 5

Tel: (949)642-7324

SECI Engineers & Buyers' Guide

Fax: (949)642-7327