E3F2

E3F2

Precautions

If the input/output lines of the Photoelectric Sensor are placed in

the same conduit or duct as power lines or high-voltage lines, the

Photoelectric Sensor could be induced to malfunction, or even be

damaged, by electrical noise. Separate the wiring, or use

shielded lines as input/output lines to the Photoelectric Sensor.

Do not subject the Photoelectric Sensor to excessive shock when

mounting, in keeping with IEC60529 IP66 standards.

Do not connect the black wire to the brown wire without a load.

Direct connection of these wires may damage the Photoelectric

Sensor (AC switching type).

Black

Brown

Blue

Load

Sensor

24 to 240 VAC

WARNING

The E3F2 Photoelectric Sensor is not a safety component for

ensuring the safety of people which is defined in EC Directive

(91/368/EEC) and covered by separate European standards

or by any other regulations or standards.

When using the Photoelectric Sensor in the vicinity of an inverter

motor, be sure to connect the ground wire of the motor to earth.

Failure to ground the motor may result in malfunction of the

Sensor.

When using the Photoelectric Sensor at temperatures over 45

°C,

the load current must be within the rated value shown in the

figure below.

Operating temperature (

°C)

200

130

55

45

0

J MOUNTING

Do not exceed a torque of

for plastic models.

nuts for metal models.

Cat. No. CEDSAX3

10/99

Specifications subject to change without notice.

Printed in U.S.A.

OMRON ELECTRONICS, INC.

One East Commerce Drive

Schaumburg, IL 60173

NOTE: DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters to inches divide by 25.4.

1-800-55-OMRON

OMRON CANADA, INC.

885 Milner Avenue

Scarborough, Ontario M1B 5V8

416-286-6465

R

!