| 数据搜索系统,热门电子元器件搜索 |
|
TMC2072 数据表(PDF) 21 Page - SMSC Corporation |
|
|
|||||||||||||||||||||||||||||
TMC2072 数据表(HTML) 21 Page - SMSC Corporation |
|
21 / 106 page ![]() Peripheral Mode CircLink™ Controller Datasheet SMSC TMC2072 Page 21 Revision 0.1 (01-30-06) DATASHEET 1.5.5 Data Bus Width Selection (W16: Pin) This pin selects the bit width of the data bus in Peripheral mode; H: 16-bit mode, L: 8-bit mode. In the 16- bit mode, the LSB address in the CircLink is fixed to 0. 1.5.6 Data Bus Byte Swap (nSWAP: Pin) In Peripheral mode, this pin selects the data order at 8-bit access. CircLink registers are defined as 16-bit width, but 8-bit access is available and in this case the assignment of lower/upper byte of registers and odd/even numbers of the address can be changed. nSWAP=L assigns the lower byte to even number address and the upper byte to odd number address, and nSWAP=H assigns the lower byte to odd number address and the upper byte to even number address. 1.5.7 Data Strobe Polarity Specification (nDSINV: pin) In Peripheral mode, this pin selects the pin polarity of data strobe (nDS). It is active low with nDSINV = H and active high with nDSINV = L. 1.5.8 Page Size Selection (PS[1:0]: Pin/Register) Selects page size per packet. The maximum number of nodes depends on the page size selection since the packet buffer size is limited to 1 kBytes. There are two methods to specify the page size: either through pin or register settings depending on INIMODE (bit 9); 0: selects pin, 1: selects register (The default is 0). 1.5.9 MAXID Number Setup (MAXID[4:0]: Pin/Register) The maximum node ID is set based on the number of nodes on the network. All nodes in a CircLink network, therefore, should have the same maximum node ID. This optimizes the time required to reconfigure the network. There are two methods to specify the maximum node ID, Either through pin or register settings depending on INIMODE (bit 9); 0: selects pin, 1: selects register (The default is 0). If the nDIAG pin is set to L as the exception, however, the maximum node ID is automatically set to the largest value. For more details, refer to section 2.10 - Diagnostic Mode. PS[1:0] Page Size Max Node Number 00 256 Byte 3 Node 01 128 Byte 7 Node 10 64 Byte 15 Node 11 32 Byte 31 Node |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |