LIS302ALB datasheet(10/17 Pages) STMICROELECTRONICS

10 / 17 page

Application hints

LIS302ALB

10/17

Application hints

Figure 3.

LIS302ALB electrical Connection

Power supply decoupling capacitors (100nF ceramic or polyester + 10

μF Aluminum) should

be placed as near as possible to the device (common design practice).

The LIS302ALB allows to band limit Voutx, Vouty and Voutz through the use of external

capacitors. The recommended frequency range spans from DC up to 2.0kHz. Capacitors

must be added at output pins to implement low-pass filtering for antialiasing and noise

reduction. The equation for the cut-off frequency (ft) of the external filters is:

Taking into account that the internal filtering resistor (Rout) has a nominal value equal to

32k

Ω, the equation for the external filter cut-off frequency may be simplified as follows:

The tolerance of the internal resistor can vary typically of ±20% within its nominal value of

32k

Ω; thus the cut-off frequency will vary accordingly. A minimum capacitance of 2.5nF for

Cload(x, y, z) is required in any case.

An external capacitor can be added to the Vout pin. Values below 10 pF are recommended.

DIRECTION OF THE

DETECTABLE

ACCELERATIONS

Digital signals

Vout X

LIS302ALB

Vout Y

Cload y

Cload x

(top view)

Optional

Vout z

Optional

Cload z

Aux In

100nF

μF

GND

Vdd

Vout

GND

Vdd

Pin 1 indicator

π R

out Cload xy z

()

⋅⋅

----------------------------------------------------------------

μF

load xy z

()

----------------------------------- Hz

[]

LIS302ALB 数据表(PDF) 10 Page - STMicroelectronics

LIS302ALB 数据表(HTML) 10 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

数据表下载