BlueCreation. St John’s Innovation Centre, Cowley Road Cambridge CB4 0WS United Kingdom

8

t. +44 (0)1223 420 252

e. info@bluecreation.com

www.bluecreation.com

BC118

Datasheet

Regulatory Certifications

BC118 is delivered with FCC, CE, IC and Bluetooth SIG certifications. This allows to integrate the module

in an end product without the need to obtain subsequent and separate approvals from these regulatory

agencies. This is valid in the case no other intentional or un-intentional radiator components are

incorporated into the product. Without these certification, an end product cannot be marketed in the

relevant regions.

United States - FCC



In case no other intentional or un-intentional radiator is incorporated, the BC118's FCC certification allows

users to integrate the module into products without the need to obtain subsequent and separate approval.



The BC118 was approved as "intentional transmitter radio module" by the United States' Federal

Communications Commission (FCC) with accordance to CFR47 Telecommunications Part 15, Subpart C,

section 212. This certification is applicable in all the states in the United States.



The certification allows products to be listed in the NRTL (National Recognized Test Laboratory) as

appointed by OSHA (Occupational Safety and Health Administration).

Labelling



The BC118 has been labelled with its own FCC ID number. In order to the extend the certification granted

to the BC118, its FCC ID number must be displayed on the finished product in which the module is

integrated. The following wording should be used "Contains Transmitter Module FCC ID: SSSBC118-X " or

“Contains FCC ID: SSSBC118-X”.



The user-manual for any product in which the BC118 is integrated in must include the following statements:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures: Reorient or relocate the receiving antenna; Increase the separation

between the equipment and receiver; Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected; Consult the dealer or an experienced radio/TV technician for help.