ESP-07S

DS-ESP07S-1

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may cause undesired

operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void

the user’s authority to operate the equipment.

Please notice that if the FCC identification number is not visible when the module is installed inside an-

other device, then the outside of the device into which the module is installed must also display a label

referring to the enclosed module. This exterior label can use wording such as the following: “Contains

FCC ID: 2AHMR-ESP07S” any similar wording that expresses the same meaning may be used.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with a minimum distance of 20cmbetween the radiator &

your body. This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

The module is limited to OEM installation ONLY.

The OEM integrator is responsible for ensuring that the end-user has no manual instruction to remove or

install module.

The module is limited to installation in mobile application;

A separate approval is required for all other operating configurations, including portable configurations

with respect to Part 2.1093 and difference antenna configurations.

There is requirement that the grantee provide guidance to the host manufacturer for compliance with

Part 15B requirements.

ESP-07S User Manual

Important European compliance information for module datasheets

This RF Solutions radio module meets the essential requirements of the European Radio Equipment

Directive 2014/53/EU and has been tested to European Harmonised Standards and CE marked where

space allows. A copy of the EU Declaration of Conformity can be located on the RF Solutions Website,

www.rfsolutions.co.uk/certification-i59.

When using the module in an end product, continued compliance can only be assured by incorporating the

module in accordance with RF Solutions specific installation instructions and in accordance with the

published information on the RF Solutions product data sheet. The antenna gain specification must be

adhered to at all times.

Article 3.1a and 3.1b of the EU Radio Equipment Directive 2014/53/EU should be assessed in the final

product.

Failure to follow this guidance may result in a non-compliant product being place on the European

Market, for which RF Solutions cannot accept any responsibility.

Further guidance may be obtained from RF Solutions Technical Support. Charges may apply to customer

specific product evaluation.