AD8353

Rev. B | Page 13 of 16

THEORY OF OPERATION

The AD8353 is a 2-stage, feedback amplifier employing both

shunt-series and shunt-shunt feedback. The first stage is

degenerated and resistively loaded and provides approximately

10 dB of gain. The second stage is a PNP-NPN Darlington

output stage, which provides another 10 dB of gain. Series-

shunt feedback from the emitter of the output transistor sets the

input impedance to 50 Ω over a broad frequency range. Shunt-

shunt feedback from the amplifier output to the input of the

Darlington stage helps to set the output impedance to 50 Ω. The

amplifier can be operated from a 3 V supply by adding a choke

inductor from the amplifier output to VPOS. Without this

choke inductor, operation from a 5 V supply is also possible.

BASIC CONNECTIONS

The AD8353 RF gain block is a fixed gain amplifier with

single-ended input and output ports whose impedances are

nominally equal to 50 Ω over the frequency range 1 MHz to

2.7 GHz. Consequently, it can be directly inserted into a 50 Ω

system with no impedance matching circuitry required.

The input and output impedances are sufficiently stable vs.

variations in temperature and supply voltage that no impedance

matching compensation is required. A complete set of

scattering parameters is available at www.analog.com.

The input pin (RFIN) is connected directly to the base of the first

amplifier stage, which is internally biased to approximately 1 V;

therefore, a dc blocking capacitor should be connected between the

source that drives the AD8353 and the input pin, RFIN.

It is critical to supply very low inductance ground connections

to the ground pins (Pin 1, Pin 4, Pin 5, and Pin 8) as well as to

the backside exposed paddle. This ensures stable operation.

The AD8353 is designed to operate over a wide supply voltage

range, from 2.7 V to 5.5 V. The output of the part, RFOUT, is

taken directly from the collector of the output amplifier stage.

This node is internally biased to approximately 2.2 V when the

supply voltage is 5 V. Consequently, a dc blocking capacitor

should be connected between the output pin, RFOUT, and the

load that it drives. The value of this capacitor is not critical, but

it should be 100 pF or larger.

When the supply voltage is 3 V, it is recommended that an

external RF choke be connected between the supply voltage

and the output pin, RFOUT. This increases the dc voltage

applied to the collector of the output amplifier stage, which

improves performance of the AD8353 to be very similar to the

performance produced when 5 V is used for the supply voltage.

The inductance of the RF choke should be approximately

100 nH, and care should be taken to ensure that the lowest

series self-resonant frequency of this choke is well above the

maximum frequency of operation for the AD8353. For lower

frequency operation, use a higher value inductor.

Bypass the supply voltage input, VPOS, using a large value

capacitance (approximately 0.47 μF or larger) and a smaller,

high frequency bypass capacitor (approximately 100 pF)

physically located close to the VPOS pin.

The recommended connections and components are shown in

Figure 40.