19

Timing Diagrams

NOTE:

7. ALI and/or BLI may be high after t1, whereupon the ENABLE pin

may also be brought high.

FIGURE 38.

NOTE:

8. Between t1 and t2 the IN+ and IN- inputs must cause the OUT pin

to go through one complete cycle (transition order is not

important). If the ENABLE pin is low after the undervoltage

circuit is satisfied, the ENABLE pin will initiate the 10ms time

delay during which the IN+ and IN- pins must cycle at least once.

FIGURE 39.

DIS

ALI, BLI

8.5V TO 10.5V (ASSUMES 5% RESISTORS)

1.7V

12V, FINAL VALUE

DIS

LDEL

=10ms

t1

t2

8.3V TO 9.1V (ASSUMING 5% ZENER TOLERANCE)

12V, FINAL VALUE

5.1V

HIP4080