AM29F040B datasheet(18/36 Pages) AMD

18 / 36 page

Am29F040B

21445E5 November 1, 2006

D A TA

SH EE T

The DQ5 failure condition may appear if the system

tries to program a “1” to a location that is previously pro-

grammed to “0.” Only an erase operation can change

a “0” back to a “1.” Under this condition, the device

halts the operation, and when the operation has ex-

ceeded the timing limits, DQ5 produces a “1.”

Under both these conditions, the system must issue the

reset command to return the device to reading array

data.

DQ3: Sector Erase Timer

After writing a sector erase command sequence, the

system may read DQ3 to determine whether or not an

erase operation has begun. (The sector erase timer

does not apply to the chip erase command.) If addi-

tional sectors are selected for erasure, the entire time-

out also applies after each additional sector erase com-

mand. When the time-out is complete, DQ3 switches

from “0” to “1.” The system may ignore DQ3 if the sys-

tem can guarantee that the time between additional

sector erase commands is always less than 50 µs. See

also the “Sector Erase Command Sequence” section.

After the sector erase command sequence is written,

the system should read the status on DQ7 (Data# Poll-

ing) or DQ6 (Toggle Bit I) to ensure the device has

accepted the command sequence, and then read DQ3.

If DQ3 is “1”, the internally controlled erase cycle has

begun; all further commands (other than Erase Sus-

pend) are ignored until the erase operation is complete.

If DQ3 is “0”, the device accepts additional sector erase

commands. To ensure the command has been ac-

cepted, the system software should check the status of

DQ3 prior to and following each subsequent sector

erase command. If DQ3 is high on the second status

check, the last command might not have been ac-

cepted. Table 5 shows the outputs for DQ3.

START

Yes

DQ5 = 1?

Yes

Toggle Bit

= Toggle?

Program/Erase

Operation Not

Complete, Write

Reset Command

Program/Erase

Operation Complete

Read DQ7–DQ0

Toggle Bit

= Toggle?

Read DQ7–DQ0

Twice

Read DQ7–DQ0

Notes:

1. Read toggle bit twice to determine whether or not it is

toggling. See text.

2. Recheck toggle bit because it may stop toggling as DQ5

changes to “1”. See text.

Figure 4.

Toggle Bit Algorithm

(Notes 1,

(Note 1)

AM29F040B 数据表(PDF) 18 Page - Advanced Micro Devices

AM29F040B 数据表(HTML) 18 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

数据表下载

链接网址

AM29F040B 数据表(PDF) 18 Page - Advanced Micro Devices

AM29F040B 数据表(HTML) 18 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

数据表 下载

链接网址

数据表下载