AM29DL322D datasheet(29/56 Pages) AMD

29 / 56 page

Am29DL322D/323D/324D

December 13, 2005

can use DQ7, or DQ6 and DQ2 together, to determine

if a sector is actively erasing or is erase-suspended.

Refer to the Write Operation Status section for infor-

mation on these status bits.

After an erase-suspended program operation is com-

plete, the bank returns to the erase-suspend-read

mode. The system can determine the status of the

program operation using the DQ7 or DQ6 status bits,

just as in the standard Byte Program operation.

Refer to the Write Operation Status section for more

information.

In the erase-suspend-read mode, the system can also

issue the autoselect command sequence. Refer to the

Autoselect Mode and Autoselect Command Sequence

sections for details.

To resume the sector erase operation, the system

must write the Erase Resume command. The bank

address of the erase-suspended bank is required

when writing this command. Further writes of the Re-

sume command are ignored. Another Erase Suspend

command can be written after the chip has resumed

erasing.

Figure 4.

Erase Operation

START

Write Erase

Command Sequence

(Notes 1, 2)

Data Poll to Erasing

Bank from System

Data = FFh?

Yes

Erasure Completed

Embedded

Erase

algorithm

in progress

Notes:

1. See Table 14 for erase command sequence.

2. See the section on DQ3 for information on the sector

erase timer.

AM29DL322D 数据表(PDF) 29 Page - Advanced Micro Devices

AM29DL322D 数据表(HTML) 29 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

数据表下载