COM20019IP datasheet(29/81 Pages) SMSC

29 / 81 page

DISCONTINUED DATASHEET

Table 4 - Status Register

BIT

BIT NAME

SYMBOL

DESCRIPTION

Receiver

Inhibited

This bit, if high, indicates that the receiver is not enabled because

either an "Enable Receive to Page fnn" command was never

issued, or a packet has been deposited into the RAM buffer page

fnn as specified by the last "Enable Receive to Page fnn"

command. No messages will be received until this command is

issued, and once the message has been received, the RI bit is set,

thereby inhibiting the receiver. The RI bit is cleared by issuing an

"Enable Receive to Page fnn" command. This bit, when set, will

cause an interrupt if the corresponding bit of the Interrupt Mask

attempts to send a packet to this station, this station will send a

NAK.

6,5

(Reserved)

These bits are undefined.

Power On Reset

POR

This bit, if high, indicates that the COM20019 has been reset by

either a software reset, a hardware reset, or writing 00H to the

Node ID Register. The POR bit is cleared by the "Clear Flags"

command.

Test

TEST

This bit is intended for test and diagnostic purposes. It is a logic

"0" under normal operating conditions.

Reconfiguration

RECON

This bit, if high, indicates that the Line Idle Timer has timed out

because the RXIN pin was idle for 656 S.

The RECON bit is

cleared during a "Clear Flags" command. This bit, when set, will

cause an interrupt if the corresponding bit in the IMR is also set.

The interrupt service routine should consist of examining the

MYRECON bit of the Diagnostic Status Register to determine

whether there are consecutive reconfigurations caused by this

node.

Transmitter

Message

Acknowledged

TMA

This bit, if high, indicates that the packet transmitted as a result of

an "Enable Transmit from Page fnn" command has been

acknowledged. This bit should only be considered valid after the

TA bit (bit 0) is set. Broadcast messages are never acknowledged.

The TMA bit is cleared by issuing the "Enable Transmit from Page

fnn" command.

Transmitter

Available

This bit, if high, indicates that the transmitter is available for

transmitting. This bit is set when the last byte of scheduled packet

has been transmitted out, or upon execution of a "Disable

Transmitter" command.

The TA bit is cleared by issuing the

"Enable Transmit from Page fnn" command after the node next

receives the token. This bit, when set, will cause an interrupt if the

corresponding bit in the IMR is also set.

COM20019IP 数据表(PDF) 29 Page - SMSC Corporation

COM20019IP 数据表(HTML) 29 Page - SMSC Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81

数据表下载