LEM

www .lem.com

Page 2/3

LEM reserves the right to carry out modifications on its transducers, in order to improve them, without previous notice.

060504/14

Current Transducer LAS 50-TP

Isolation characteristics

V

d

R.m.s. voltage for AC isolation test, 50/60 Hz, 1 mn

5

kV

V

w

Impulse withstand voltage 1.2/50 µs

>8

kV

V

e

R.m.s. voltage for partial discharge extinction @ 10pC

>2

kV

Min

dCp

10.70

mm

dCl

10.70

mm

CTI

Comparative Tracking Index (Group III a)

175

Application examples

According to EN 50178 and IEC 61010-1 standards and following conditions :

On PCB with soldering pattern UTEC93-703.

Safety

This transducer must be used in electric/electronic equipment with respect to

applicable standards and safety requirements in accordance with the following

manufacturer's operating instructions.

Caution, risk of electrical shock

When operating the transducer, certain parts of the module can carry hazardous

voltage (eg. primary busbar, power supply).

Ignoring this warning can lead to injury and/or cause serious damage.

This transducer is a built-in device, whose conducting parts must be inaccessible

after installation.

A protective housing or additional shield could be used.

Main supply must be able to be disconnected.

EN 50178

IEC 61010-1

dCp, dCI

Rated isolation voltage

Nominal voltage

Single isolation

1000 V

1000 V

Reinforced isolation

500 V

500 V