AH503

High sensitivity Unipolar Hall switch sensor

REV1.2

06/2023

www.alfaelecs.com

西安中科阿尔法电子科技有限公司

12

15.Note

➢ Hall chips are sensitive devices, and electrostatic protection measures should be taken during use,

installation, and storage.

➢ During installation and use, mechanical stress applied to the device casing and leads should be

minimized as much as possible.

➢ It is recommended that the welding temperature should not exceed 350 ℃ and the duration should

not exceed 5 seconds.

➢ To ensure the safety and stability of Hall chips, it is not recommended to use them beyond the

parameter range for a long time.

16. Historical Version

No.

Time

Describe

1

September 6th, 2022

Update Characteristic Performance。

2

December 22th, 2022

Update static voltage output error range

3

February 9th, 2023

Update IC limit of operate temperature and storage temperature

4

April 19th, 2023

Version update to V1.2

Copyright ©2018, Alfa Electronics Co ., Ltd

Alfa Electronics Co ., Ltd reserves the right to make, from time to time, such departures from the detail

specifications as may be required to permit improvements in the performance, reliability, or manufacturability

of its products. Before placing an order, the user is cautioned to verify that the information being relied upon

is current.

Alfa’s products are not to be used in any devices or systems, including but not limited to life support devices

or systems, in which a failure of Alfa’s product can reasonably be expected to cause bodily harm.

The information included herein is believed to be accurate and reliable. However, Alfa Electronics Co ., Ltd

assumes no responsibility for its use; nor for any infringement of patents or other rights of third parties which

may result from its use.