Visit product website 

Kick and Drop coils

Visit product website 

DATA SHEET

Type 6013



Plunger valve 2/2-way

direct-acting

Type 6014



Plunger valve 3/2-way

direct-acting

Type 6027



Direct-acting 2/2-way

plunger valve

Type 6213



Servo-assisted 2/2-

way diaphragm valve

Type 6281



Servo-assisted 2/2-

way diaphragm valve

Type 5404



Servo-assisted 2/2-

way piston valve

Type 6240



Servo-assisted 2/2-

way piston valve

Standard | EU | en | 2023-11-16 | 04

© Christian Bürkert GmbH & Co. KG, changes reserved

Solenoids with Kick and Drop

• Two windings encapsulated in one coil with epoxy

• Inrush power increases performance and differential pressure range

for small installation volumes

• Holding power reduces to less than 1 W with over 80% energy

saved

• Less heating reduces calcification and increases service life

• Internal electronics assembly covers direct and alternating voltage

with frequencies 50 Hz and 60 Hz

The Kick and Drop variants of the AC10 and AC19 coil types use two wind-

ings in one solenoid. Thanks to an increased inrush power for the first wind-

ing, the switchable pressure range is increased as installation volumes stay

the same. The second winding is switched in series after 500 ms. Thanks to

this reduced holding power, energy is saved and coil heating is reduced.

Product variants described in the data sheet may differ from the product presentation and description.

Type description

Can be combined with