
8-106
RF2461
Rev B6 060925
Pin
Function
Description
Interface Schematic
1
LNA GAIN
Controls the bypass feature of the LNA. A logic low (<1.0V) selects the
bypass mode. A logic high (>2.0V) turns on the LNA.
2
MIX GAIN
Controls the bypass feature of the mixer preamp. A logic low (<1.0V)
selects the bypass mode. A logic high (>2.0V) turns on the preamp-
preamp.
3LNA IN
LNA input pin.
4VCC1
VCC pin for all circuits except the LO. Buffer/bias circuitry.
5GND1B
LNA emitter. This pin provides the DC path to ground for the LNA. A
lumped element or a transmission line inductor can be placed between
this pin and ground to degenerate the LNA. This will decrease the gain
and increase the IP3 of the LNA. As the value of inductance is
increased, these effects will become more pronounced.
6LNA OUT
LNA output pin.
See pin 3.
7
ISET2
An external resistor R2 connected to this pin sets the current of the
preamp and the mixer.
8
ISET1
An external resistor R3 connected to this pin sets the current of the
LNA when IP SET is high (see pin 19).
9GND3B
Ground pin for preamp circuit. A 3.3nH inductor is used between pin 9
and ground to degenerate the mixer preamp. Degenerating the preamp
will reduce the gain, increase the IP3 and affect the preamp input
impedance.
10
MIX IN
Mixer preamp input pin.
See pin 9.
11
IF1-
Second differential output pin for the first mixer.
See pin 12.
12
IF1+
First differential output pin for the first mixer. Open collector. A current
combiner external network performs a differential to single-ended con-
version and sets the output impedance. A DC blocking cap must be
present if the IF filter input has a DC path to ground. Mixer (IF2+ and
IF-) needs to “see” a differential impedance between 2k
Ω to 4kΩ.
13
BYPASS
Bypass pin for the LO bias reference.
14
IF2-
Second differential output pin for the second mixer.
See pin 15.
LNA GAIN
MIX GAIN
LNA IN
LNA OUT
GND1B
MIX IN
GND3B
VCC2
IF1-
IF1+