K100

Page 3 of 3

Disclaimer: This data sheet is for reference only. All specifications are subject to change without prior notice. KG Technologies, Inc. cannot predict

every possible application for our relays. While we do our best to make our relays as versatile as possible, we highly recommend contacting our

engineering team if you have any questions. KG Technologies, Inc. is not responsible for malfunctioning relays when operated outside the specified

parameters given in this data sheet.

KG Technologies, Inc. / Phone: +1.888.513.1874 / Fax: +1.888.511.3989 / Email: info@kgtechnologies.net / Web: www.kgtechnologies.net

102012

Wiring Diagrams

1: All relays are shipped in the “Closed” position. It is possible that during transit or final assembly the relay could change its state to the

“Open” position. Therefore, it is recommended that all relays be set to the desired state of the relay via a power supply.

2: In order to maintain an “Open” or “Closed” state of the relay, the coil voltage should reach the rated voltage. The pulse width should

be 50ms minimum to ensure a proper change of state. DO NOT energize both T1 and T3 at the same time on a Dual Coil or energize

the coil for longer than 1 minute (damage to the coil could incur).

3: Relays without flex-wire cannot be tin-soldered. Moving or bending the terminals could cause damage to the internal structure of

the relay.

4: For definitions of terms used in this data sheet, see glossary at www.kgtechnologies.net.

Additional Application Notes

Dual Coil

Single Coil

Dual Coil – Positive Polarity: Place a negative connection on T2. Then apply a 50ms positive pulse to T1 to open the contacts or

to T3 to close the contacts.

Dual Coil – Negative Polarity: Place a positive connection on T2. Then apply a 50ms negative pulse to T3 to open the contacts or

to T1 to close the contacts.

Single Coil: Place a negative connection on T1. Then apply a 50ms positive pulse to T3 to close the contacts. Reversing polarity will open

the contacts.

Application Notes

Dual Coil Connection

Single Coil Connection

T1

T3

T2

Positive Polarity

Negative Polarity

T1

T3

T2

T1

T3

T1 T2 T3

Dual Coil

T1

T3

Single Coil