M45PE10 datasheet(13/45 Pages) STMICROELECTRONICS

13 / 45 page

M45PE10

Operating features

13/45

4.3

A fast way to modify data

The Page Program (PP) instruction provides a fast way of modifying data (up to 256

contiguous bytes at a time), provided that it only involves resetting bits to 0 that had

previously been set to 1.

This might be:

●

when the designer is programming the device for the first time

●

when the designer knows that the page has already been erased by an earlier Page

Erase (PE) or Sector Erase (SE) instruction. This is useful, for example, when storing a

fast stream of data, having first performed the erase cycle when time was available

●

when the designer knows that the only changes involve resetting bits to 0 that are still

set to 1. When this method is possible, it has the additional advantage of minimizing the

number of unnecessary erase operations, and the extra stress incurred by each page.

For optimized timings, it is recommended to use the Page Program (PP) instruction to

program all consecutive targeted Bytes in a single sequence versus using several Page

Program (PP) sequences with each containing only a few Bytes (see Page Program (PP)

and AC characteristics (50 MHz operation)).

4.4

Polling during a Write, Program or Erase cycle

A further improvement in the write, program or erase time can be achieved by not waiting for

the worst case delay (tPW, tPP, tPE, or tSE). The Write In Progress (WIP) bit is provided in the

Status Register so that the application program can monitor its value, polling it to establish

when the previous cycle is complete.

4.5

Reset

An internal Power On Reset circuit helps protect against inadvertent data writes. Addition

protection is provided by driving Reset (Reset) Low during the Power-on process, and only

driving it High when VCC has reached the correct voltage level, VCC(min).

4.6

Active Power, Standby Power and Deep Power-Down modes

When Chip Select (S) is Low, the device is selected, and in the Active Power mode.

When Chip Select (S) is High, the device is deselected, but could remain in the Active Power

mode until all internal cycles have completed (Program, Erase, Write). The device then goes

in to the Standby Power mode. The device consumption drops to ICC1.

The Deep Power-down mode is entered when the specific instruction (the Deep Power-

down (DP) instruction) is executed. The device consumption drops further to ICC2. The

device remains in this mode until another specific instruction (the Release from Deep

Power-down and Read Electronic Signature (RES) instruction) is executed.

All other instructions are ignored while the device is in the Deep Power-down mode. This

can be used as an extra software protection mechanism, when the device is not in active

use, to protect the device from inadvertent Write, Program or Erase instructions.

M45PE10 数据表(PDF) 13 Page - STMicroelectronics

M45PE10 数据表(HTML) 13 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45

数据表下载