TSA1203

Application information

15/30

8

Application information

The TSA1203 is a dual-channel, 12-bit resolution high speed analog-to-digital converter

based on a pipeline structure and deep sub-micron CMOS process to achieve the best

performance in terms of linearity and power consumption.

Each channel achieves 12-bit resolution through the pipeline structure which consists of 12

internal conversion stages in which the analog signal is fed and sequentially converted into

digital data. A latency time of 7 clock periods is necessary to obtain the digitized data on the

output bus.

The input signals are simultaneously sampled, for both channels, on the rising edge of the

clock. The output data is delivered on the rising edge of the clock for channel I, and on the

falling edge of the clock for channel Q, as shown in Figure 2: Timing diagram on page 4. The

digital data produced at the various stages must be time-delayed according to the order of

conversion. Finally, a digital data correction completes the processing and ensures the

validity of the ending codes on the output bus.

The TSA1203 is pin-to-pin compatible with the dual 10 bits/20 Msps TSA1005-20, the dual

10 bits /40 Msps TSA1005-40 and the dual 12 bits/ 20 Msps TSA1204.

8.1

Additional functions

To simplify the application board as much as possible, the following operating modes are

provided:

●

Output enable (OEB) mode

●

Select mode

8.1.1

Output enable mode (OEB)

converter goes on sampling. When OEB is set to a low level again, the data arrives on the

Figure 2: Timing diagram on page 4 summarizes this functionality.

If you do not want to use OEB mode, the OEB pin should be grounded through a low value

resistor.

8.1.2

Select mode (SELECT)

The digital data output from each of the ADC cores is multiplexed to share the same output

bus. This prevents an increase in the number of pins and allows to use the same package as

for a single-channel ADC like the TSA1201.

Q data is delivered on D0-D11.

By connecting SELECT to CLK, channel I and channel Q are simultaneously present on D0-

D11, channel I on the rising edge of the clock and channel Q on the falling edge of the clock.

(refer to Figure 2: Timing diagram on page 4).